Fronius Selectiva 2040 2kW Operating Instructions Manual page 28

-
-
The procedure for opening the configuration menu is as follows:
28
CAUTION! Risk of damage to the battery. Only use the automatic num-
ber of cells selection function with batteries with the following nominal
voltage values:
12 V and 24 V with 24 V devices
24 V and 48 V with 48 V devices
The automatic selection function must not be used with deep discharged
batteries.
- "Additional functions":
for individual adaptation options for the charging characteristic
"General options": General options
- Language
- Contrast
- Time (hh:mm:ss)
Time zone
Daylight saving time/normal time
- Date (dd:mm:yy)
- Length of charging lead (m)
- Charging lead cross section (mm
- Code for accessing the configuration menu activated/deactivated
- Time interval for the parameter recorded on the USB flash drive (s)
"Reset Factory Settings": resets settings to those when the charger left the factory or
optionally to Fronius defaults
- includes a double-check ("OK?") that requires the operator to reconfirm that this
step is intended
The "Up/Down" keys can be used to retrieve the following informa-
1
tion:
- Serial number of the device plus serial number and version of
the configuration memory
- PC board for controller/power electronics: hardware version
and serial number
- Software: main software, secondary software, primary soft-
ware
Press the "Stop/Start" key
1
2
)
First the screen will appear in its initial for-
mat, showing the date, time and software
version.