Long Term Storage - KRAUSE & BECKER 60600 Owner's Manual

if Sprayer is not properly cleaned immediately after every use.
Clean Sprayer immediately to prevent permanent damage.

Long Term Storage

When cleaning for long term storage (more than 48 hours).
It is very important that the Paint Sprayer is not stored with
any water or water-based material left in the Pump, Hose,
Tubes, or Spray Gun. This will corrode the product.
IMPORTANT: Clean the
Sprayer before storage.
See "Cleaning" on
pages 16-17.
1. Remove paint hose if not
already removed.
2. Turn the unit over and
loosen the Clamps
from both Tubes, then
disconnect Tubes from
the Pump Body.
3. Add one ounce of light
household oil or a
pump storage product
into each inlet.
4. Turn Prime/Spray switch
to Spray.
5. Turn Pressure Control
Knob to Low/Spray.
Page 18
RETURNS NOT ACCEPTED & WARRANTY VOID
Hi Spray Low Spray Prime/Clean
For technical questions, please call 1-888-866-5797.
6. Hold a rag over the paint
hose outlet.
7. Switch Power to ON for
five seconds, then turn the
power OFF.
8. Turn Prime/Spray switch
to Prime, this will keep
storage fluids in sprayer.
9. Replace the Tubes and
secure with the Clamps.
10. Wipe the sprayer with a clean cloth. Store in a
clean dry location out of reach of children.
Roll
ON 5 seconds
then OFF
ITEM 60600