Long Term Storage - KRAUSE & BECKER 68001 User Manual

Clean the Sprayer ImmedIAtely after use. delayed or inadequate cleaning will permanently clog the
Spray Gun. Warranty void if sprayer is not properly cleaned immediately after every use.

long term Storage

When cleaning for long term storage (more than 48 hours).
It is very important that the Paint Sprayer is not stored
with any water or water-based material left in the Pump,
Hose, Tubes, or Spray Gun. This will corrode the product.
1. Clean the Sprayer before storage.
See "Cleaning" on pages 16-17.
2. Remove paint hose if not already removed.
3. Turn the unit over and loosen the Clamps from both
Tubes, then disconnect them from the Pump Body.
4. Add one ounce of light household oil into each inlet.
Page 18
Notice
For technical questions, please call 1-800-444-3353.
Hi Spray Low Spray Prime/Clean
5. Turn Prime/Spray switch to Spray.
6. Hold a rag over the paint hose outlet.
7. Switch Power to ON for five seconds,
then turn the power OFF.
Hi Spray Low Spray Prime/Clean
8. Turn Prime/Spray switch to Prime,
this will keep storage fluids in sprayer.
9. Replace the Tubes and secure with the Clamps.
10. Wipe the sprayer with a clean cloth. Store in a
clean dry location out of reach of children.
Roll
Roll
SKU 68001