Painting; Painting Techniques - KRAUSE & BECKER 60600 Owner's Manual

if Sprayer is not properly cleaned immediately after every use.
Clean Sprayer immediately to prevent permanent damage.

Painting

Before painting, ensure the Sprayer has been primed
(see Priming and Startup steps) and verify
that Nozzle Tip is aligned properly.
Note: Remove or cover objects that you want
to protect from overspray and paint mist.
1. Once primed, adjust nozzle to Spray setting.
Hi Spray Low Spray Prime/Clean
2. Start spraying at the lowest setting on the Pressure
Control Knob and increase pressure as needed by
turning clockwise to create a good spray pattern.
3. Practice the Painting Techniques that follow on a
scrap workpiece before painting your workpiece.
Page 14
RETURNS NOT ACCEPTED & WARRANTY VOID
Roll
For technical questions, please call 1-888-866-5797.

Painting Techniques

Before painting, ensure the Sprayer has been primed
(see Priming and Startup steps) and
verify that Nozzle Tip is aligned properly.
Keep the gun approximately 1 foot from the surface.
1. Keep gun straight and move arm across at a steady
rate while staying one foot from the surface.
2. Do not fan the gun or paint will be uneven.
3. Overlap strokes by half, always aim
stroke at bottom edge of last stroke.
Overlap
Strokes
ITEM 60600