Intended Purpose - Seitron CHEMIST 400 Use And Maintenance Manual

INTENDED PURPOSE

This chapter describes the areas of application for which the CHEMIST 400 is intended.
Using the CHEMIST 400 in other application areas is on the risk of the operator and the manufacturer assumes
no responsibility and liability for loss, damage or costs which could be a result. It is mandatory to read and pay
attention to the operating/maintenance manual.
All products of the series CHEMIST 400 are handheld measuring devices in professional flue gas analysis for:
Small furnaces (burning oil, gas, wood, coal)
•
Low-temperature and condensing boilers
•
Gas heaters
•
Due to other configuration with electrochemical cells it is possible to use the measuring instrument in following
application area:
Service engineers/mechanics of burner/boiler manufacturers
•
Service industrial combustion plants
•
The measuring instrument is approved for measurements under German regulations on immissons protection (1.
1
BImSchV) .
Additional functions of the measuring instrument:
Flue gas analysis according 1. BImSchV or qA-mean value (selectable)
•
Calculating of stack heat loss and efficiency
•
CO- and NO environment measurement
•
Tightness test
•
Store Smoke value, calculating mean value
•
Measuring differential pressure
•
Draught measurement
•
CHEMIST 400 should not be used:
For continuous measurements > 1h
•
As safety alarm instrument
•
1 Valid for configurations equipped with the following sensors:
O sensor:
2
CO+H sensor:
2
NO sensor (optional):
6
Cod. AAC SE11
Cod. AAC SE12
Cod. AAC SE10.
K900000000SE 022628A0 071013