Once the Model IM1/1 is installed, it should operate transparently.
This sections describes power-up, general operating instructions, and
the LED status monitors.
6.1 OPERATING INSTRUCTIONS
In order to operate, the Model IM1/I must be installed in the base
unit. It also requires a 10Base-T connection. After power is applied,
the IM1/I automatically starts performing the bridging function without
further user intervention. MAC addresses discovered are automatically
loaded into the MAC address table. They are automatically deleted
from the MAC address table if they experience an inactivity of 8
minutes.
6.2 POWER-UP
Before applying power to the IM1/I, please be sure it is properly
installed in the base unit. Then make sure that unit is connected to the
appropriate power source (Universal Interface AC Power Supply or
DC Power Supply). Then power-up the base unit using the rear power
switch .
6.0 OPERATION
12