D • Port pin-outs
Introduction
This section provides pin-out information for the ports of the SmartNode.
Console port
Configuration settings: 9600 bps, 8 bits, no parity, no flow control
Note
Pins not listed are not used.
Ethernet 10Base-T and 100Base-T port
Note
Pins not listed are not used.
FXS port
The FXS ports use an RJ-11 connector with 6 positions. The midle two positions 3 and 4 are used according
to
table
13.
78
Figure 34. EIA-561 (RJ-45 8-pin) port
Table 12. RJ-45 socket
Pin
1
2
3
6
Table 13. RJ-11 socket
Pin
3
Model 4520 & 4110 Series Getting Started Guide
Signal
TX+
TX-
RX+
RX-
Signal
Ring (-)
Introduction