Table of Contents
Advertisement
Term (Green)
The Term LED glows solid under the following circumstances:
• 3088/CA with V.35 interface: If the serial interface has asserted DTR
• 3088/D with the X.21 interface:
– Configured as DCE: Indicates that the "Control" signals have
been asserted.
– Configured as DTE: Indicates that the "Indication" signals have
been asserted
TM/ER (Red)
The Test Mode/Error (TM/ER) LED is used to indicate that a test mode is
in progress or an error has been detected. It blinks once every second
while a test mode is starting. It glows solid while a test mode is in
progress. It blinks once if an error is detected either during a test mode,
or in normal DSL operation.
A.7 CONFIGURATION
Externally accessible DIP switches or SNMP managed through 3096RC
A.8 POWER
5 VDC from external desk top power supply, 90-260VAC, 50-60 Hz (Uni-
versal Input), 10W
A.9 COMPLIANCE
FCC Part 15, CE, ACTA (FCC Part 68): IC-CS03
A.10 TRANSMISSION LINE
Single Twisted Pair
A.11 LINE CODING
TC-PAM (Trellis Coded Pulse Amplitude Modulation)
A.12 LINE RATES (DSL LINE)
All nx64 rates from 64 kbps up to 4.6 Mbps
44
Advertisement
Table of Contents
