Patton electronics 3088 User Manual page 27

Rocketlink-g ntu g.shdsl modem

Hide thumbs Also See for 3088:

Table of Contents

Follow the instructions below to activate RocketLink Plug 'n' Play

between CO (Model 3096RC and CP (Model 3088) units:

• Set the Model 3096RC (CO) to either Internal or External clocking

mode as deﬁned by the application.

• Set the Model 3088 (CP) to "RocketLink Plug-and-Play CP" by setting

S1 and S2 DIP switches in the ON position as described in ﬁgure 4.

3096RC

(CO)

DIP Switches or NMS configured

according to specific application

requirements

Figure 4. Typical RocketLink Plug 'n' Play Application

When the CO and CP units connect over DSL, the CP will enter a pre-

deﬁned default conﬁguration (Receive Recovered Clocking). During the

negotiation process between the units, the CO unit will conﬁgure the

DTE rate/line rate on the CP unit as deﬁned by the settings of the CO

unit. When additional bandwidth is required, only the conﬁguration of the

CO unit should be changed. This feature gives ISPs, LECs and PTTs the

ability to provision bandwidth on an as needed basis to customers.

DSL Span

DIP Switches all in ON position

3088

(CP)

Table of Contents

Rocketlink-g 3088