Table of Contents
Advertisement
) for connection to DCE such as a modem or multiplexer. When
ment
connecting the X.21 interface of the Model 3088/D to your DTE or DCE
device, use an X.21 straight-through cable (See figure 8).
DSL Span
Remote Model 3088)
Straight-Through 15-pin
D-Sub Cable
Router (DTE)
OR
Mux (DCE)
Model 3088/D (DCE or DTE)
Figure 8. Connecting the Model 3088/D to X.21 DTE or DCE
To change the DCE/DTE orientation from the default position (DCE), you
must open the case Model 3088/D case.
Opening the Case
To open the Model 3088/D case, insert a flat head screw driver into an
open slot on both sides of the case, as in figure 9. Twist the screw driver
head slightly and the top half of the case will separate from the lower
half, as in figure 9. Be careful not to damage the PC-board
mounted components.
Figure 9. Opening the 3088 case with a small screwdriver
31
Advertisement
Table of Contents
