Table of Contents
Advertisement
The dsl clear errcntrs command clears the error counters.
Remote Console
Provided that there is a DSL link to a second 3088, a user may login to
the first 3088's console and enter the remote console command to
access the second 3088's console. Using this remote console feature,
the user can configure and query the status of the second 3088 from a
remote location. When the user is finished with the remote console, the
logout command can be used to return to the local console.
Example Command Line Interface Session
password: ******
> system set circuitid "3088 Circuit ID"
> system set timeslots 3
> system set clockmode internal
> dsl set annex b
> dsl set lineprobe disabled
> system save config
> dsl start
> system show status
leds: power: on dsl: on tm/er: off
dsl test mode:
ber status: idle
errors:
time:
front panel switches: sw1: normal sw2: normal
dsl link state: success
configuration mode: software
> dsl show status
link state: success
sync state: in sync
link speed: 192k
error counters:
crc:
losw:
tx fifo full:
tx fifo empty: 0
tx fifo slip:
tx stuff:
rx fifo full:
rx fifo empty: 0
rx fifo slip:
line condition: good
noise margin: 3.5
> remote console
0
0
0
0
0
0
0
0
0
25
Advertisement
Table of Contents
