Lucent Technologies CellPipe IAD 4A Hardware Installation Manual page 7

In addition, if the equipment is to be used with telecommunications circuits, take the
following precautions:
•
•
•
•
•
•
!
!
!
CellPipe IAD 4A and CellPipe IAD 8T Hardware Installation Guide
a qualified electrical consultant to determine whether or not this phenomenon
exists.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using equipment connected to telephone lines (other than a cordless
telephone) during an electrical storm. There is a remote risk of electric shock
from lightning.
Do not use a telephone or other equipment connected to telephone lines to report
a gas leak in the vicinity of the leak.
Warning: To reduce the risk of fire, communication cable conductors must be
2
26 AWG (0.13 mm ) or larger.
Avertissement: Afin de réduire les risques d'incendie, les fils conducteurs du
câble de communication doivent être d'un calibre minimum de 26 AWG
(American Wire Gauge), c'est-à-dire d'un minimum de 0,13 mm².
Warnung: Um Feuer-Risiko zu reduzieren, müsssen die Querschnitte der
Kommunikationskabel-Leiter 0,13 mm² oder größer sein.
Important safety instructions
vii