Mitsubishi i-MiEV 2011 Owner's Manual page 72

Display of MiEV Remote during communicating with
vehicle
It communicates with the vehicle when the power of the MiEV
Remote is turned on with pressing the power supply/communi-
cation switch (B) for 1 second or more and if the power sup-
ply/communication switch (B) is pressed for less than 1 second
while the power of the MiEV Remote is on.
If the normal reception melody sounds after the transmitting
melody, it is set completion.
Communication symbol (F) blinks while communicating with
the vehicle.
If the buzzer sounds with ERROR symbol (G) blinks, a prob-
lem is detected. Refer to "Actions to be taken when the MiEV
Remote system does not operate correctly" on page 1-67.
To cancel Charging Timer
There are two methods to cancel Charging Timer.
N01203800011
By using the MiEV Remote
By operating the electric motor switch on the vehicle
NOTE
If the Charging Timer is canceled during charging, the
charging will continue until the Main Drive Lithium-ion
Battery is fully charged.
If the Charging Timer is canceled before charging starts,
charging will start immediately and continue until the
Main Drive Lithium-ion Battery is fully charged.
Charging Timer cannot be canceled by disconnecting the
charge connector before the time set by the ON timer. The
Charging Timer will resume when the charging connector
is again connected to the vehicle.
A. By using the MiEV Remote
1. When the power of MiEV Remote is off, turn the
power ON. Refer to "To turn the MiEV Remote
ON/OFF" on page 1-50.
General information/Charging
N01203900012
1-57
1