Mitsubishi i-MiEV 2011 Owner's Manual page 245

Features and controls
Setting the passcode
Use the following procedure to turn on the security function by
setting a passcode.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Passcode."
4. The voice guide will say "Passcode is disabled. Would
you like to enable it?" Answer "Yes."
Answer "No" to cancel the setting of the passcode and
return to the main menu.
5. The voice guide will say "Please say a 4-digit passcode.
Remember this passcode. It will be required to use this
3
system."
Say a 4-digit number which you want to set as a passcode.
6. For confirmation purposes, the voice guide will say "Pass-
code <4-digit passcode>. Is this correct?" Answer "Yes."
Answer "No" to return to the passcode input in Step 5.
7. When the registration of the passcode is completed, the
voice guide will say "Passcode is enabled" and the system
will return to the main menu.
NOTE
Passcode will be required to access the system after
restarting the electric motor unit.
It is required for a little time after the ready indicator has
turned off that the entered passcode is actually recorded in
the system. If the electric motor switch is made to "ACC"
or "ON" or the electric motor is started immediately after
the ready indicator has turned off, there is a case when the
entered passcode is not recorded in the system. At this
time, please try to enter the passcode again.
3-96
Entering the passcode
If a passcode has been set and the security function is enabled,
the voice guide will say "Hands-free system is locked. State the
passcode to continue" when the SPEECH button is pressed to
enter voice recognition mode. Say the 4-digit passcode number
to enter the passcode.
If the entered passcode is wrong, the voice guide will say "<4-
digit passcode>, Incorrect passcode. Please try again." Enter
the correct passcode.
NOTE
You can reenter the passcode as many times as you want.
If you have forgotten your passcode, say "Cancel" to quit
the voice input mode and then check with a certified i-
MiEV dealer.
Disabling the passcode
Use the following procedure to turn off the security function by
disabling the passcode.
NOTE
System must be unlocked to disable the passcode.
1. Press the SPEECH button.
2. Say "Setup."
3. Say "Passcode."
4. The voice guide will say "Passcode is enabled. Would you
like to disable it?" Answer "Yes."
Answer "No" to cancel the disabling of the passcode and
return to the main menu.
5. When the disabling of the passcode is completed, the
voice guide will say "Passcode is disabled" and the sys-
tem will return to the main menu.