Delete The Stored Data; Transfer The Stored Data To Pc - KYORITSU 6050 Instruction Manual

9.3 Delete the stored data

Stored data can be deleted according to following sequence.
(1) Press MEMORY MODE SWITCH ("MEM MODE" SWITCH) on
stand-by (at "Lo V" is displayed).
Then instrument becomes MEMORY MODE, and "
appears on the LCD. The action of each switch changes as shown
under each switch.
(2) Press MEMORY RECALL SWITCH ("RCL" SWITCH).
(3) Select the Data you want to delete with MEMORY SELECT
SWITCH ("MEM▼▲"SWITCH).
Select "ALL" when you delete all data.
(4) Press MEMORY CLEAR SWITCH ("CLR"SWITCH).
The "clr" is displayed with blinking on LCD.
(5) Press ENTER SWITCH ("ENT" SWITCH) and delete the selected
data.
● By pressing MEMORY MODE EXIT SWITCH ("EXIT" SWITCH)
during an operation, can undo the last action.
● When making a measurement, press MEMORY MODE EXIT
SWITCH("EXIT" SWITCH) and release the MEMORY MODE.
Measurement cannot be performed when Test button is pressed
while " MEM

9.4 Transfer the stored data to PC

The stored data can be transferred to PC via Optical Adapter Model
8212 (Option).
● How to transfer the data:
(1) Firmly insert the D-SUB 9Pin female connector of Model 8212 into
the socket(D-SUB 9Pin male ) of PC.
(2) Insert Model 8212 into Model 6050 as shown in fig.18.
Test Leads shall be removed from Model 6050 at this time.
(3) Turn on Model 6050. (Any function is OK.)
(4) Start special software "KEW REPORT" on
your PC and set the communication port.
Then click "Down load" command, and the
data in Model 6050 will be transferred to
your PC. Please refer to the instruction
manual of Model 8212 and HELP of KEW
REPORT for further details.
" mark is being displayed on the LCD.
― 27 ―
MEM " mark
Fig.18