MacDon R85 Unloading And Assembly Instructions page 55

R85 13 Foot Rotary Disc Pull-Type Mower Conditioner Pre-Delivery Checklist
Perform these checks and adjustments prior to delivery to your customer. See the Unloading and Assembly Instructions for
details. The completed checklist should be retained either by the Operator or the Dealer.
CAUTION: Carefully follow the instructions given. Be alert for safety related messages which
bring your attention to hazards and unsafe practices.
WARNING: Do not operate the machine with the drive shields open. High speed rotating
components may throw debris and could result in death or serious injury.
Header Serial Number: _____________________ APT Hitch Serial Number___________________________

Check for shipping damage or missing parts. Be sure all shipping dunnage is removed.
Check for loose hardware. Tighten to required torque.
Check main drive belt tension.
Check bevel gearbox oil level.
Check header angle to middle of adjustment range.
Check header float. 95–105 lbf (426–471 N)
Check tire pressure. 30 psi (207 kPa)
Check wheel bolt torque. 120 ft·lbf (160 N·m)
Check hydraulic oil level at sight glass on side of APT hitch.
Check side deflectors evenly set to desired position.
Ensure shields are at equal distance from center line of tongue pivot.
Check rear deflector about half way down.
Check swath baffle set about halfway.
Grease all bearings and drivelines.
Check conditioner roll gap and timing.
Check roll intermesh hardware is securely tightened.
Check cutterbar curtains are hanging properly and are latched.
Check hydraulic hose and wiring harness routing.
Check cutterbar area carefully for loose parts and hardware on the cutterbar.
WARNING: These objects can be ejected with considerable force when the machine is
started and may result in serious injury or machine damage.
RUN-UP PROCEDURE
Check hydraulic hose and wiring harness routing for clearance when raising or lowering header.
Check tail lights and hazard lights are functional.
POST RUN-UP CHECKS. STOP ENGINE.
Check belt drive for idler alignment and heated bearings.
Check for hydraulic leaks.
Check header manuals in storage case.
Date Checked: ________________________________
169561
ITEM
Checked By: _________________________________
PAGE
---
5
43
43
22
44
21
21
18
34
34
35
38 – 42
45 – 46
46
14 -15
---
---
48
---
47
43
---
47
Revision C