Step 21. Install Forming Shield; Attach Forming Shield; Install Supports - MacDon R85 Unloading And Assembly Instructions

STEP 21. INSTALL FORMING
SHIELD
A. ATTACH FORMING SHIELD
a. Place forming shield on lift forks, and position
forming shield up to header.
b. Slide forming shield onto header.
c. Locate shield to align holes in forward row.
Install five 3/8 in. x 0.75 long carriage bolts and
nuts in forward row at locations (A) to hold
shield. Nuts on inside. Do NOT tighten.
d. Back forklift away from work area.
RIGHT SHOWN - LEFT OPPOSITE
e. Install four 1/2 in. x 1.0 long carriage bolts and
nuts (B) at sides of shield. Do NOT tighten.
169561
UNLOADING AND ASSEMBLY
A
B
33
C
RIGHT SHOWN - LEFT OPPOSITE
f. Install four 1/2 in. x 1.0 long carriage bolts (C) at
forward corners. Do NOT tighten.
B. INSTALL SUPPORTS
a. Retrieve supports and hardware bag that were
removed from shipping locations in earlier steps.
G
F
RIGHT SIDE SHOWN - LEFT SIDE OPPOSITE.
(CROP DEFLECTOR NOT SHOWN FOR CLARITY)
b. Position support (D) through slot in frame, and on
inboard (outboard optional) side of mounting plate
(E).
If necessary, lower crop deflector to allow
installation of supports.
c. Install two 1/2 in. x 1.0 long carriage bolts (F) and
nuts through support and mounting plate (E). Do
NOT fully tighten bolts.
d. Attach support (D)
3/8 in. x 0.75 long carriage bolts and nuts (G).
e. Repeat for other support.
D
E
NOTE
to cover with
(continued next page)
Revision C
three