Step 10. Install Hydraulic Motor - MacDon R85 Unloading And Assembly Instructions

Rotary disc 13 foot pull-type mower conditioner

Hide thumbs Also See for R85:

Table of Contents

STEP 10. INSTALL HYDRAULIC

MOTOR

a. Remove shipping wire that holds motor to

steering cylinder.

b. Remove four bolts (A) securing plate (B) to

gearbox, and remove plate. Retain bolts.

c. Position motor (C) on gearbox as shown, and

re-install the four bolts (A). Torque to 103 ft·lbf

(140 N·m).

169561

UNLOADING AND ASSEMBLY

d. Route hoses through hose guides.

If required, loosen the hose swivel fittings at

the motor ports to remove any twist in the

hose routing from the APT hitch. Do NOT

loosen the clamp type fitting.

NOTE

Revision C

Table of Contents