Step 2. Unload Header - MacDon R85 Unloading And Assembly Instructions

STEP 2. UNLOAD HEADER
CAUTION
To avoid injury to bystanders from being
struck by machinery,
persons to stand in unloading area.
CAUTION
Equipment used for unloading must meet
or exceed the requirements specified
below. Using inadequate equipment may
result in chain breakage, vehicle tipping or
machine damage.
LIFTING VEHICLE
Minimum Capacity
Minimum Height
Overhead Lifting Quality
(1/2 inch)
WARNING
Be sure forks are secure before moving
away from load. Stand clear when lifting.
169561
UNLOADING AND ASSEMBLY
do NOT allow
8,000 lb. (3,630 kg)
15 ft. (4.5 m)
CHAIN
5,000 lb. (2,270 kg)
Minimum Working
Load
a. Remove hauler's tie down straps and chains.
FORKS
b. Approach mower conditioner from either its
underside or
underneath lifting framework as far as possible.
When possible,
underside
scratching the unit.
c. Raise mower conditioner off deck.
Take care not to contact the other machine
if load is two-wide.
d. Back up until unit clears trailer, and slowly lower
to 6 inches (150 mm) from ground.
e. Take to storage or set-up area, and set machine
down securely on level ground.
f. Repeat for other mower conditioner if required.
g. Check for shipping damage and missing parts.
11
topside, and slide
NOTE
approach from
to minimize potential
IMPORTANT
forks in
the
for
Revision C