Step 4. Remove Shipping Channels And Blocking - MacDon R85 Unloading And Assembly Instructions

STEP 4. REMOVE SHIPPING
CHANNELS AND
BLOCKING
a. Cut the banding on the shipping beam at the
rear of carrier frame, and remove components
from inside the shipping beam.
NOTE
Hardware bag is for STEP 21. INSTALL
FORMING SHIELD.
b. Place LH spring assembly (heavy) near LH
side of carrier. Place RH spring assembly
(light) near RH side of carrier.
NOTE
The following steps remove the stand as
an assembly. These components may
also be removed individually.
c. Place blocks under the shipping beam at the
rear of the carrier frame.
169561
UNLOADING AND ASSEMBLY
d. Loosen the shipping stand bolt at the lower end of
e. Remove the bolt that secures shipping stand at
f.
g. Remove bolts at carrier frame legs, and remove
h. Cut banding that secures angles to carrier frame
13
each carrier frame leg.
each float spring anchor.
Remove the support blocks, and lower the
shipping stand to the ground.
shipping stand frame.
tube, and remove angles.
Revision C