RadioLink t8fb Instruction Manual page 3

Note:About flying
While you are getting ready to fly, if you place your transmitter on the ground ,be sure that
the wind won't tip it over. If it is knocked over, the throttle stick may be accidentally moved,
causing the engine to speed up. Also, damage to your transmitter may occur.
Other than 2.4GHz system: Before operating, be sure to extend the transmitter antenna to its
full length, collapsed antenna will reduce your flying range and cause a loss of control.It is a
good idea to avoid pointing the transmitter antenna directly at the model, since the signal is
weakest in that direction.
In order to maintain complete control of your aircraft it is important that it remains visible at
all times .
Flying behind large objects such as buildings, grain bins, etc. are not suggested. Doing so may
result in the reduction of the quality of the radio frequency link to the model.
2.4GHz system: Do not grasp the transmitter module's antenna during flight.Doing so may
degrade the quality of the radio frequency transmission.
2.4GHz system: As with all radio frequency transmissions, the strongest area of signal
transmission is from the sides of the 8CH transmitter module's antenna. As such, the antenna
should not be pointed directly at the model.If your flying style creates this situation,easily
move the antenna to correct this situation.
Warning!!!
Please don't fly in the rain! Water or moisture may enter the transmitter internal through gaps in
the antenna or joystick flight and cause your flight to instability even out of control. If inevitable
will fly in the wet weather (such as game), please be sure to use plastic bags or waterproof cloth to
cover your transmitter, please don't flight if there is lightning.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
2