Battery, Fuse And Tyres; Storage - CareCo DAYTONA Owner's Manual

6.3 BATTERY, FUSE AND TYRES

■ Battery
Refer to the section entitled '5.2 BATTERY' in '5. BATTERY CHARGING AND CARE'.
■ Fuse
If the battery charger is turned on and no LEDs are lit, check the fuse.
 Suggestion
Ask for help from CareCo to inspect or replace the fuse, as the tiller shroud has to be
removed before the fuse can be replaced. Contact Customer Services on 0845 611 8022 or
email: cs@careco.co.uk
▓TYRES
The condition of the tyres depends on how you drive and use your scooter.
 Inspecting tyre tread
 Please check the tread groove regularly. Replace the tyres when the tread groove is less
than 0.5 mm.
 Attention
１. When tread depth is below 0.5mm the scooter may not grip well making braking
distances longer. Therefore replace the tyres as soon as they are found to have insufficient
tread depth.
２. The tyre pressure should be kept at about 26 PSI (approx. 1.8KG/cm) for the best ride and
handling.
 Attention
When carrying out maintenance of your vehicle, please turn the power switch to OFF and
remove the charger cords.
 Suggestions
 Do not splash water directly onto your scooter when washing as this could lead to
malfunction of the system electrics.
 Do not use petrol or solvents as these may damage the shrouds.
 Do not use wax.

6.4 STORAGE

Make sure the vehicle is stored as follows:-
The seat is set in the 'Forward' position
-
The Power switch is turned to 'OFF'
-
 Suggestion
Store your Daytona scooter out of direct sunlight, rain and damp conditions. When storing
for a length of time, please charge the battery to full power and then disconnect the battery
terminal. For details contact CareCo Customer Services on 0845 611 8022 or email:
cs@careco.co.uk
16