Troubleshooting - Wallbox PULSAR Installation Manual

TROUBLESHOOTING

Your network supply is continously checked to ensure a safe operation of the device. If one of the parameters is not in range the charger will stop the power
supply to the vehicle
The charging process uses a secure comunication protocol (called Control Pilot) between your wallbox and the vehicle. If the car detects a problem
during the charging process, it will be interrupted. At this point a message will pop up on your status menu.
The internal stats of the charger are also being parameterized in real time. A change in the normal operating values will lead the
charger to safely disconnect the power supply to the vehicle
MAINTENANCE
Please take the following precautions to ensure a correct maintenance :
There are no parts inside your Wallbox Pulsar that need to be maintained by the user. Only qualified electrician can open and manipulate
your Wallbox.
Remember to ensure that the power supply is turned o , before you start cleaning your Wallbox Pulsar.
In case you want to clean your Wallbox Pulsar, we recommend you to use a soft dry or damp cloth. Do not use a spray or direct water to clean
your Wallbox Pulsar.
It is mandatory to use the protection element or support, provided as an accessory, in order to protect the connector from falling, dirt and other
meteorological elements.
PULSAR
- installation guide en 17