Safety Instructions - Wallbox PULSAR Installation Manual

SAFETY INSTRUCTIONS 1/2

Follow all of the safety instructions below and take special care to keep this manual handy. This installation manual is intended for qualified
personnel only.
Do not operate in case of observing physical defects, such as cracks, breaks, corrosion or other damage. In this case please contact your distributor to
get the Wallbox device replaced.
Only authorized specialists can open, disassemble, repair, manipulate or modify the Wallbox device. Unauthorized modification of the Wallbox
equipment voids the manufacturer' s warranty.
Unauthorized modifications or conversions are absolutely forbidden.
Do not remove any notices on the device, such as safety symbols, warnings notices, rating plates, nameplates or cable markings
Protect your Wallbox from any impacts or waypoints to which it could be exposed..
The charging station does not have its own power switch. Allways follow your local electrical regulations and norms, as applicable.
The Wallbox chargers can only be used under the specified operating parameters (Product description) and within the normal environmental
conditions described below:
Environmental conditions¹:
¹ Do not use your wallbox Pulsar under inclement weather conditions that could a ect either the vehicle or the charging device itself.
Do not open the connector panel cover in the rain.
PULSAR
- installation guide
Ambient temperature range
Average temperature
Storage temperature
Relative humidity
Between -25ºC and 40ºC
< 35ºC
Between -40ºC and 70ºC
Between 5% and 95% (Non condensing)
en 5