Self - Paradyne COMSPHERE 3910 Installation And Operation Manual

To access Abort from the Test branch, make the following selection:
Select Abort.
The modem stops all tests currently in progress and displays the Command Complete status
message on the LCD.
To exit this function and remain in the Test branch, press the
Top-Level menu, press the

Self

Self performs an internal self-test of the modem, which takes less than a minute to complete. The
modem must be offline; otherwise, Invalid Command appears.
To access Self from the Test branch, make the following selection:
Select Self. (All LCD cells and DCP status indicators light.)
3910-A2-GN32-30
Test:
Abort Self
F1 F2 F3
Test:Abort
Command Complete
F1 F2 F3
key.
When this test is run in Remote mode, it will cause the Remote
mode session to be lost. The Remote mode session can be
reestablished after the self-test is complete (usually one or two
minutes). If the remote self-test fails, there will be a Device
Failure alarm message when the remote modem's Device
Health and Status (DeviceHS) branch is accessed.
Test:
Abort Self
F1 F2 F3
November 1996
>
key. To exit and return to the
WARNING
>
DCP Operation
3-47