Paradyne COMSPHERE 3910 Installation And Operation Manual page 167

AT
Command
\D n CTS Control.
\D0
\D1
\D2
\D3
\D4
\G n Modem to Modem Flow Control.
\G0
\G1
\K n Buffer Control, Send Break Control, Break Forces Escape.
\N n Error Control Mode.
\N0
\N1
\N2
\N3
\N4
\N5
\N6
\N7
\Q n Flow Control of DTE, Flow Control of Modem.
3910-A2-GN32-30
391x Series AT Commands
Description
Forced On. Forces CTS to always ON.
Standard RS232.
Wink When Disconnect. CTS is turned OFF for 1 to 2 seconds
upon a disconnect.
Follows DTR. The state of CTS follows the state of DTR.
Follows RTS. The state of CTS follows the state of RTS.
Disable.
Enable.
Break Buffer
Control:
\K0 Discard Data
\K1 Discard Data
\K2 Keep Data
\K3 Keep Data
\K4 Keep Data
Keep Data
\K5
Buffer Mode.
Direct Mode.
MNP or Disconnect.
MNP or Buffer.
V.42/MNP or Disconnect.
V.42/MNP or Buffer.
LAPM_or_Disc
LAPM_or_Bufr
Flow Control
of DTE:
\Q0 Disable
\Q1 XON/XOFF
\Q2 CTS to DTE
\Q3 CTS to DTE
\Q4 XON/XOFF
\Q5 Disable
\Q6 Disable
November 1996
Table 5-3
(7 of 8)
Send Break Break Forces
Control: Escape:
Break First Enable
Break First Disable
Break First Enable
Break First Disable
Data First Enable
Data First Disable
Flow Control
of Modem:
Disable
XON/XOFF
Disable
RTS to Mdm
Disable
XON/XOFF
RTS to Mdm
AT Command Set and S-Registers
DCP LCD
Command
Sequence
Configure\Edit\
DTE Interface
Configure\Edit\
V42/MNP/Buffer
Break Buffer
Control:
Configure\Edit\
V42/MNP/
Send Break
Control:
Configure\Edit\
V42/MNP/Buffer
Break Forces
Escape:
Configure\Edit\
DTE Dialer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
5-13