Paradyne COMSPHERE 3910 Installation And Operation Manual page 73

Cloning a Single TMp Remote
Press the F1 key to select Single Clone Remote.
The address field (xxx) displays the network management address of the modem that will receive
the download. The valid address field range is from 001 to 256.
To increment digits within the address field (xxx), use the
( _ ) under the digit that will be incremented. Press the F2 ( ) key to increment the digit.
Press Enter (Ent) to select the modem that will receive the download.
The password field (yyyyyyyy) displays the remote access password for the modem that will
receive the download.
To increment digits within the password field (yyyyyyyy), use the
cursor ( _ ) under the digit that will be incremented. Press the F2 ( ) key to increment the digit.
Press Enter (Ent) to select the modem that will receive the download.
After completing these actions, proceed to the section titled Implementing a Clone Remote
Operation.
3910-A2-GN32-30
For Multiple download configurations, ensure that the control modem's active poll list
contains all the network management addresses for the remote tributary modems that will
receive the download (refer to the Poll List section in this chapter), and ensure that the
tributaries are responding properly to polls (refer to the Sub-Network Health and Status
Branch section in this chapter).
Choose DLL Type >
Single Multiple
F1 F2
Choose Address:
Ent xxx
F1 F2
Choose Password:
Ent yyyyyyyy
F1 F2
November 1996
F3
F3
and
F3
DCP Operation
keys to position the cursor
and keys to position the
3-39