Configuration Options; Cables - Paradyne COMSPHERE 3910 Installation And Operation Manual

COMSPHERE 3900 Series Modems

Configuration Options

3920 A
3920 B
3910 A
3910 B
3910 C

Cables

Cable 1
Cable 2
Cable 5
G-8
Use Sync Leased (Answer) default configuration options with the following
exception:
Rate at 19.2K
Use Sync Leased (Originate) default configuration options with the following
exceptions:
TX Clock Source
Rate at 19.2K
Port TXC Source
Use TMp (Control) default configuration options with the following exceptions:
TX Clock Source
LeasedLine Rate
Use TMp (Trib) default configuration options with the following exceptions:
TX Clock Source
LeasedLine Rate
Use TMp (Trib) default configuration options with the following exceptions:
TX Clock Source
LeasedLine Rate
Use a standard, customer-supplied, EIA-232-D/V.24 cable with a DB-25-P (plug)
connector at one end to attach to the modem. Attach this to the connector labeled
DTE1, 2, 3, or 4.
Use part number 125-0053-1431 (an 8-position, 8-wire modular cord that is
supplied with the modem). Attach this to the connector labeled LEASED.
Use part number 818-2759-0111 or an equivalent customer-supplied,
EIA-232-D/V.24 crossover cable with DB-25-P (plug) connectors on both ends to
attach to the modems. (See Appendix C for pin assignments.)
November 1996
Set ports 1, 2, 3, and 4 to 4800.
Set to RXC_Loop.
Set ports 1, 2, 3, and 4 to 4800.
Set port 4 to External.
Set to External.
Set to 4800(TMp).
Set to RXC_Loop.
Set to 4800(TMp).
Set to RXC_Loop.
Set to 4800(TMp).
3910-A2-GN32-30