Implementing A Clone Remote Operation - Paradyne COMSPHERE 3910 Installation And Operation Manual

COMSPHERE 3900 Series Modems
Cloning a Multiple TMp Remote
Press the F3 key to select Multiple Clone Remote.
After completing this action, proceed to the next section, Implementing a Clone Remote Operation.
Viewing Multiple TMp Clone Results
From the Choose DLL Type screen, press the
view the results of the last multiple TMp clone operation. If the message Trib List Empty appears,
this indicates that a multiple download was never initiated.
The address field (xxx) displays the network management address of one of the remote modems.
Pressing the F1 key allows you to select various remote modems to determine the download result
for those modems (Pass or Fail).

Implementing a Clone Remote Operation

3-40
Choose DLL Type >
Single Multiple
F1 F2 F3
Choose DLL Type >
MPtCloneResults
F3
F1 F2
MPtCloneResults
Nxt xxx Pass
F1 F2 F3
The modem begins a transfer of its own program to the remote
modem. This process takes the communication link
out-of-service for several minutes depending on the data rate
of the link. If the Clone Remote process is started and then
interrupted, the remote modem is left in a partially programmed
state in which its functional capabilities are limited to those
required to initiate and complete another download attempt.
November 1996
key until the MPtCloneResults screen appears to
WARNING
3910-A2-GN32-30