Self-Test Results - Paradyne HotWire 7985 User Manual

Monitoring the Unit

Self-Test Results

4-4
Table 4-1. Health and Status Messages
Message What Message Indicates
Download Failed A firmware download was
interrupted.
Net Com Link The Network communication
Down link is down. Communications
between the management
system and the LTU/NTU is
not possible.
The results of the last power-up or reset self-test appear in the middle column of
the System and Test Status screen.
Table 4-2. Self-Test Results Messages
Message What Message Indicates
CPU Failed The CPU failed internal testing.
DeviceFailed One or more of the Model 7985
Standalone Termination Unit's
integrated circuit chips has failed
device-level testing.
Net DSL The Model 7985 Standalone
Failed, Pt 1 Termination Unit failed to loop data
on the network DSL circuit of Port 1.
SYNC Pt The Model 7985 Standalone
Failed, Pt 1 Termination Unit failed to internally
loop data on the synchronous Port 1.
Memory The Model 7985 Standalone
Failed Termination Unit failed memory
verification.
Failure An internal failure occurred.
xxxxxxxx (xxxxxxxx represents an 8-digit
hexadecimal failure code for use by
service personnel.)
Passed No errors were detected.
October 1998
What To Do
Repeat the download.
Verify that the network cable is
securely attached at both ends.
What To Do
1. Reset the unit and try again.
2. Call your service
representative for assistance.
1. Reset the unit and try again.
2. Call your service
re resentative for assistance. representative for assistance.
Record the failure code and
contact your service
representative.
7985-A2-GB20-00