Table of Contents
Advertisement
1.
System
1.0 Parts Identification
1. LCD Display
2. Programming Buttons
3. Antenna
4. Battery Socket Outlet
5. Battery Charger
1. LCD Display
Displays the icon based applications stored in the handset.
2. Programming Buttons
Use these five (5) buttons to program, modify, review and communicate
with a LEIT-2 and LEIT-2ET controller.
Use to raise (increase) the value of the selected parameter or
to unlock the secure password and controller ID
Use to lower (decrease) the value of the selected parameter
Use to accept and/or select the desired programming mode
Use to move the cursor to the right
Use to move the cursor to the left
3. Antenna
See FCC compliance.
4. Battery Socket Outlet
Plug the battery charger into the battery socket.
5. Battery Charger
Plug the battery charger into the wall to power the LEIT RC2ET.
b
d
c
e
f
8
1.1 Battery charger outlets and recharging the battery
The LEIT RC2ET handset contains a cell battery pack that is rechargeable
using the AC/DC wall mounting charger 120 or 220 VAC/60 h2, 12 VDC @150
mA. To charge the LEIT RC2ET handset, plug the wall mount charger into
the wall and connect the power connector into the side of the LEIT RC2ET
handset. The initial charge takes approximately 8 hours. Do not disconnect
the handset during the initial charge. When in use, the handset should be
charged daily for a few hours as needed. If the handset is charged, you will
see a charging icon and a battery appear. The battery repeats a filling action,
indicating that the battery is charging. Once the battery is charged, it will stop
the filling motion, and the wording CHARGED will appear. A car charger model
30-851 is available, if needed. The LEIT RC2ET handset is ready for setup and
communication.
2.
Using the LEIT RC2ET Handset
After charging the handset, press
The initial screens will show the DIG logo, time/date, software version and the
MAIN MENU. Check the bottom of display for menu title at any time.
2.0 Handset Main Menu (from left to right)
The LEIT RC2ET handset MAIN MENU screen has six (6) icons, each used to
set or select an option. The first option, RADIO UPLINK, is used to connect to
a LEIT-2ET controller. Next, SETUP is used to set the time, contrast and ID
number for the handset. In LANGUAGE, select one (1) of the six (6) languages
available. HELP provides contact information if any problem with the system
is encountered, and FIND allows the user to connect to the last ten (10)
controllers, if any were connected previously. The final icon, TURN OFF, is
used to turn off the handset.
SW V: 1.6
EE V: 1.1
10:00:00 AM
MONDAY
7/13/2009
TIME / DATE
VERSION
10:00
10:00
10:00
ARE YOU SURE?
to navigate through the initial screens.
10:00
US
MAIN MENU
10:00
10:00
9
CONNECTING
CONNECTED
Advertisement
Table of Contents
