Copyright And Compliance - DIG LEIT RC2ET Instruction Manual

Two-way weather based radio remote control handset

Hide thumbs Also See for LEIT RC2ET:

Table of Contents

LEIT WWS and LEIT WWSE are each trademarks of DIG Corporation.

Patent Pending.

FCC, IC and CE certified, Australia and Hong Kong compliance

To comply with FCC RF exposure compliance requirements, the antenna used for this

transmitter is installed to provide a separation distance of at least 8 inches (20 cm) from all

persons (not including hands, wrist, feet and ankles) and must not be colocated or operating in

conjunction with any other antenna or transmitter.

This device is required to comply with FCC RF exposure requirements for mobile and fixed

transmitting devices. This model transceiver generates and uses radio frequency energy.

If not installed and used in accordance with the manufacturer's instructions, it may cause

interference to radio and television reception.

CONTROLLER FCC ID: UJV-LEIT01

HANDSET FCC ID: UJV-LEIT02

WEATHER STATION FCC ID: UJV-LEIT03 IC: 6694A-LEIT03

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy. If not installed and used in accordance with the

instructions, the remote may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• C onnect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult DIG technician for help.

Warning: the user should make no field changes or modifications to the LEIT-2ET controller,

LEIT RC2ET handset, LEIT WWS or LEIT WWSE weather station. All adjustments and changes

must be made at DIG's facility under the specific guidelines suggested in our instruction manual.

Any tampering or modification to the equipment will void the users authority to operate the unit,

render the equipment in violation of FCC part 15 and will void the warranty.

IC: 6694A-LEIT01

IC: 6694A-LEIT02

Table of Contents