Electronic Programme Guide (Epg) - Strong SRT 2400 User Manual

ToneBurst If you are using a legacy type switch to switch between 2 satellites, setup your port to the
satellite you selected above.
DiSEqC 1.0 If you are using a DiSEqC 1.0 switch to switch between 2, 3 or 4 satellites, setup your port
to the satellite you have selected above.
DiSEqC 1.1 If you are using a DiSEqC 1.1 to switch between 5 to 16 satellites, setup your port to the
satellite you've selected above.
Motor If you are using a motor drive to move between satellites, setup the motor drive by using
DiSEqC 1.2 or Goto X protocols.
note:We strongly advise to ask your local installer to help install motor and settings.
There is also the possibility to change (add, edit or delete) a satellite or transponder by pressing InFO
and search for channels: Auto search, Manual search, Blind scan and Network search. Press the BLUE
button to display the Scan menu and press OK to confirm.
7.5.2 DvB-t / t2 Installation
In this menu you can select Country, Antenna power, LCN modes and search for channels.
Below in the screen you will find level and quality bars for optimizing the best signals of your
terrestrial antenna.
Country Settings: Select your region.
Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present at the ANT
IN connector of the receiver. Select Off for passive antennas.
LCN: Set LCN (Logical Channel Numbering) to On to activate operator defined channel numbering or
Off to store channels in found order. Sorting of channels in the channel list with LCN is not possible.
Auto Scan: Select to start searching all frequencies for available channels. All stored channel from
before will be deleted.
Manual Scan: Select to start searching on one frequency for available channels. All stored channel
from before will be kept in the channel list. When all settings have been made, press OK to start
scanning.
Scan Type: Select FTA to search and store channels which can be watched freely. Select All to include
encrypted channels in the channel list. However this device does not decode any channels.
7.5.3 DvB-C Installation
For cable installation select DVB-C in the DTV tuner section. If you don't make that selection the DVB-T
menu options will be displayed. The process of auto search and manual search works in the same
way as described in the DvB-t chapter above.

7.6 Electronic Programme Guide (EPG)

The Electronic Programme Guide (EPG) shows programme schedules and information for current
programmes and coming programmes up to the 7 next days. Press EPG button on remote to open
the EPG in viewing mode. To change to other channel, press the rED and GrEEn buttons. Press
t upq to navigate in the EPG menu. Press OK to get detailed information about the programme.
Press the BLUE Timer button to set a reminder for a programme or to programme a recording.
21