Table of Contents
Advertisement
step 7: Satellite Installation:
step 8: DVB-T/T2 Installation DVB-C:
step 9: Antenna Power: Switch to On if you use an active antenna. By setting to On, 5 V will be present
step 10: LCN.:
step 11: Scan Type:
nOtE:
By the time all settings are finished, select Auto scan for full search of all channels or select Manual
Scan for only one frequency. Press OK to start scanning. The receiver will search for all available
channels now. When the scanning is finished, the receiver switches to viewing mode.
step 12: Load channel list from USB:
step 13: Load preset Satellite list Germany:
nOtE:
After the above steps have been made the receiver will go into viewing mode and you can use and
enjoy it. Should some steps not be set as you wish or if you like to restart the wizard, you can do so
from the DTV part. Please press
selection DVB-T/T2 Installation allows you to search terrestrial channels by
using an indoor or outdoor antenna. The third option is DVB-C which allows
you to search cable broadcasted channels.
The default setting is ASTRA 19.2 on DiSEqC port 1. Use pq if you would
like to select a different satellite signal and press OK to select or deselect. To
modify the settings, press u to enter. When all settings are finished, press
BLUE and select Scan to enter the scanning process menu. Select the Scan
type here. By selecting Sat Type and Multi, you may scan multiple satellites, by
selecting Single you scan only one satellite signal. Press OK to start.
The receiver shows the Aerial Adjustment screen. First select the country
where you are using the device to set up the steps in the scanning process
automatically.
at the ANT IN connector of the receiver. Select Off for passive antennas.
Switch to On if your operator uses automatic channel sorting also called as
LCN. This option does not allow any manual channel sorting afterwards.
Select Off if you would like to sort the channels yourself after the scanning
process.
Select All to store scrambled and Free-To-Air channels or select FTA to store
only Free-To-Air channels.
Scrambled channels cannot be viewed with this receiver.
Select this option and press u if you like to load a channel list which has been
made before and was saved as backup on a USB stick.
Select this option and press u if you like to load the channel list from ASTRA
19.2 made for German users including most important channels.
Over time, channels can be moved to other frequencies, completely
disappear and new channels can appear. Please add these manually if you
miss them or check our website www.strong.tv for latest updates.
and select DTV settings and confirm with OK to enter.
11
Advertisement
Table of Contents
