Honeywell hus-nvr-1032-e User Manual page 66

System Operation and Configuration
60
Figure 5-60 Configure Trigger Profiles
New Profile
1. Click New Profile and click
device.
2. Click on the added alarm device to select the trigger condition in the dropdown list;
3. Click in "Triggered Device" window to add triggered device, as shown in the
following figure:
Figure 5-61 Add Alarm Device and Triggered Device
4. Configure the added device in "Camera Settings" window. To remove a device, select
that row and click Remove, as shown in the following figure:
Figure 5-62 Camera Settings
5. Configure "Alarm Output", "Show Message" and "Audible Alarm" in "System Settings"
window as the figure below:
in the pop-up "Alarm Device" window to add alarm