Wireless - Motorola nvg589 Administrator's Hanbook

Administrator's Handbook
Link: Wireless

Wireless

When you click the
Wireless LAN elements.
The Wireless page's center section contains a summary of the Wireless Access Point's configuration
settings and operational status.
Field
Wireless Operation
Network Name (SSID)
Hide SSID
Security
WPA Version
WEP Key Length
Key
Mode
Bandwidth
Channel
Power Level
Wireless Protected Setup
(WPS)
◆
The Wireless Operation function is automatically enabled by default. If you uncheck the checkbox, the Wire-
less Options are disabled, and the Wireless Access Point will not provide or broadcast its wireless LAN ser-
vices.
46
link the Wireless page appears. The Wireless page displays the status of your
Summary Information
General Information
May be either On or Off.
This is the name or ID that is displayed to a client scan. The default SSID for the
Gateway is attxxx where xxx is the last 3 digits of the serial number located on
the side of the gateway.
May be either Off or On . If On, your SSID will not appear in a client scan.
The type of wireless encryption security in use. May be OFF-No Privacy , WPA-
PSK or WEP , Default Key or Manual .
If WPA is selected, may be Both, WPA-1, or WPA-2,.
May be 10 characters for 40/64-bit, or 26 characters for 128-bit WP encryption.
Here you can enter a manual encryption key.
May be 802.11B only, 802.11G only, 802.11N, or 802.11 B/G/N.
The capacity of the wireless LAN to carry traffic in megahertz, 20 or 40.
The radio channel that your Wi-Fi network is broadcasting on.
May be adjusted up to 100%, lower if multiple wireless access points are in use,
and might interfere with each other.
May be either On or Off.
Status and/or Description