Button Sound; Select Image File; Delete Image File - Kanguru KCLONE-1HD-MBC User Manual

Button Sound / Select Image File / Delete Image File

7.3 Button Sound

The BTN. SOUND option allows you to enable or disable the audible tone that sounds when you tap
or hold a button. Tap the 'RUN' button to change this option's setting.
• [ ‫٭‬ ] – Button sounds are enabled (default). Tapping a button will be accompanied by a short
tone. Holding a button will be accompanied by a long tone followed immediately by a higher
pitched tone.
• [ ] – Button sounds are disabled. No audible tones will sound when you tap or hold a button.

7.4 Select Image File

SEL IMG FILE is used for selecting an image file that has been saved to a Storage Center.
To select an image file:
1. From the SETUP menu, tap the 'SET' button to navigate to the SEL IMG FILE option.
2. Tap the 'RUN' button. The digit furthest to the right will be blinking, indicating that it is currently
selected. Tap the 'RUN' button to increase the digit by one.
3. Tap the 'SET' button to select the next digit to the left. Tap the 'RUN' button to increase the
digit by one. Repeat this step as necessary.
4. When you have completed selecting an image file, hold the 'RUN' button to confirm your
selection.

7.5 Delete Image File

DEL IMG FILE is used for deleting an image file that has been saved to a Storage Center.
To delete an image file:
1. From the SETUP menu, tap the 'SET' button to navigate to the DEL IMG FILE option.
2. Tap the 'RUN' button. The duplicator will ask you to input the name of the image file you want
to delete.
a) The file name consists of three digits. The digit furthest to the right will be blinking, indicating
that it is currently selected. Tap the 'RUN' button to increase the digit by one.
b) Tap the 'SET' button to select the next digit to the left. Tap the 'RUN' button to increase the
digit by one. Repeat this step as necessary.
3. When you have completed entering the name of the image file, hold the 'RUN' button to delete
the image file.
Note: If the screen displays the following message, "NO FILE_SYS IN SRC" then there is no data
saved to the image file that you selected.
SETUP
>[000] SEL IMG FILE
SETUP
>[000] DEL IMG FILE
23