Fig. 804 Permissible Installation Position Of Exhaust Pipe End; Electrical Connections - Webasto Air Top Evo 40 Workshop Manual

Service Work
Fig. 804 Permissible installation position of exhaust
pipe end
WARNING
If the exhaust pipe ends is other than as shown in the Fig. 804
it will pose a fire risk.

8.6.6 Electrical connections

8.6.6.1 Heater connection, control element
The electrical connection is to be made as shown in the ap-
propriate wiring diagram (see Chapter 7).
To connect the wiring harness, remove the cover (see
9.2.1.1) on the heater and connect the wiring harness plug
to the control unit.
Before using the heater for the first time fit the cover to pre-
vent the illegal escape of hot air (heater overheating).
The wiring harness can be routed either to the left or right
from the heater.
8.6.6.2 Supply voltage connection
Ideally from the vehicle's central electrical system.
An additional blade terminal fuse holder is to be fitted to pro-
tect the heater (supplied with the heater). The fuse holder
may only be installed in the interior of the vehicle.
804
Visit www.butlertechnik.com for more technical information and downloads.
www.butlertechnik.com
Air Top Evo 40 / Air Top Evo 55
Fig. 805 Remove the fastening plate on the fuse holder
F = 15 A (24 V)
F = 20 A (12 V)
Fig. 806 Fuse holder, installation position