Content Dual Top Evo 6 Content Introduction .................... 3 Maintenance ..................17 Disinfection ..................17 Maintenance and Safety Information ........... 4 Descaling ..................18 Function description ................6 Troubleshooting ..................19 Summer mode (hot water only) ............6 Fuses .....................21 Winter mode (heating without hot water production) ..... 7 Winter mode (heating with hot water production) ......
Please take the time to read this manual carefully. This enables you to use all features and makes you feel comfortable and safe. To ensure safe use of the Dual Top Evo 6 heater, ALWAYS read and follow all instructions in this manual.
If the vehicle to which the Dual Top Evo 6 is fitted becomes involved in an NOTE accident, or if the Dual Top Evo 6 falls to the floor, it must be returned to an The regulations of these guidelines are binding in the scope of the EU authorised Webasto Service Centre for a safety inspection/repair.
Page 5
The Dual Top Evo 6 heater shall be directly connected to the battery. very high thermal stress and must be replaced by genuine Webasto spare parts Switching the heater on and off must only be done with the Dual Top Evo 6 ten years after these are used for the first time.
The heater is used for providing hot drinking water. The water is heated up to and kept Due to its outside installation and it operation with diesel fuel, the Dual Top Evo 6 saves at 40 °C or 70 °C.
Dual Top Evo 6 Function description Winter mode (heating without hot water production) Winter mode (heating with hot water production) The desired interior temperature can be adjusted with the interior temperature selector The heater is used for heating the interior and production of hot water.
Operating Instructions Dual Top Evo 6 Operating Instructions General The operating instructions and the "Maintenance and Safety Information" must always be observed before the start! The vehicle owner is responsible for the correct operation of the appliance. Before using for the first time, it is essential to disinfect and rinse the entire water supply system with drinking water (see chapter 7: "Maintenance").
Dual Top Evo 6 Operating Instructions 4.1.2 Interior temperature sensor Normal operation To measure the room temperature, a remote interior temperature sensor is located in 4.2.1 Summer mode (hot water only) the vehicle. The location of the sensor is determined by the installer, and is depended on the vehicle type and interior layout.
Operating Instructions Dual Top Evo 6 4.2.2 Winter mode (heating without hot water production) 4.2.3 Winter mode (heating with hot water production) Move interior temperature selector (B) on the control panel to desired thermostat Make sure that the boiler is filled with water.
Attention when driving in cold conditions: will flash. Run the Dual Top Evo 6 in winter mode (heating with hot water production) to protect the water pipes outside the vehicle against frost. In this case, the operating mode selector knob (A) on the control panel must be set to the winter mode, heating without hot water production (3) and water filled into the boiler if required.
Operating Instructions Dual Top Evo 6 Frost NOTE Any kind of water from the vehicle has to be discharged at a proper disposal facility. There are several features that protect the water supply system against frost. NOTE • Drain water contents manually when there is risk of frost and when storing the Drainage can be stopped by again moving mode selector knob (A) to drainage mode vehicle for a longer period.
Dual Top Evo 6 Operating Instructions The drainage outlet of the electrical safety/drainage valve must always be kept clear 4.3.3 Frost protection mode (free from dirt, ice, leaves etc.)! This mode is a safety feature for the heater only. It does not prevent the water circuits To avoid water loss and to protect the heater and boiler against frost, select the frost inside and outside the vehicle from freezing.
Operating Instructions Dual Top Evo 6 Switching off Move mode selector knob (A) to "OFF" (7) to switch off. The fan can continue to run after switching off in order to cool down the heater. After this, the green indicator (C) goes off.
Dual Top Evo 6 Filling the boiler Filling the boiler Fill the vehicle fresh water tank with your own hose, which is kept and stored clean. Before filling the tank rinse the hose thoroughly (approx. 30 seconds). WARNING Always fill the tank with drinking water only and prevent dirt from getting into the entire water supply system.
The meaning of the number of red flashing pulses is shown in the table in chapter 8: "Troubleshooting". After that, again there will be 5 fast GREEN flashing pulses. Depending on the type of fault, you may need to visit a Webasto Service Centre. “n” 5 x green “n”...
Maintenance Maintenance Disinfection Correct maintenance of a Webasto Dual Top Evo 6 integrated heater is important to ensure years of trouble free safe use and enjoyment. We recommend taking the vehicle to your authorised Webasto dealer for periodic • In case no water has been taken from the water supply system for a period of a week service and inspection.
, Puriclean). Other products can harm your health and/or the Dual Top Evo 6. Depending on the hardness of the water, used for heating in the Dual Top Evo 6, scaling and lime deposits can form in the coolant hoses and the boiler. In order not to restrict Carefully follow all instructions of the NaOCl supplier.
WARNING In case you are a person not trained by Webasto for Dual Top Evo 6, all repair tasks are done at your own risk. To avoid injuries and damage, the device must be switched off and the battery disconnected before working on the Dual Top Evo 6.
Page 20
Troubleshooting Dual Top Evo 6 Fault message output on control panel Number of Meaning Remedy flashing pulses No communication between control panel and heater, or First, remove fuses 15 A (red cable) and 5 A. Then put in fuse 15A (red cable), followed by fuse 5 A.
17 red flashing pulses: no shut-off, but the flashing pulses indicate a failure. Fuses The Dual Top Evo 6 is equipped with 3 fuses: 5 A, 15 A and 15 A. Each fuse must be connected to the corresponding cable (observe colour).
Webasto network of authorized dealers. Terms and conditions Please note that the Dual Top Evo 6 is only specified for applications in motor homes or similar vehicles. The quality and good operation of Webasto Dual Top Evo 6 products are guaranteed by Webasto for a period of two (2) years, starting from the date of installation.
Page 23
Warranty Certificate Installed in vehicle type Self-adhesive label Max. permissable weight Date of initial registration of Validation & Commissioning Date of Installation vehicle Approved Report available Stamp of installing workshop...
Page 24
Control Card Installed in vehicle type Self-adhesive label Max. permissable weight Date of initial registration of Validation & Commissioning Date of Installation vehicle Approved Report available Stamp of installing workshop...
Page 25
In multilingual versions the German language is binding. The telephone number of each country can be found in the Webasto service center leaflet or the website of the respective Webasto representative of your country. Webasto Thermo & Comfort SE Postfach 1410...
Need help?
Do you have a question about the Dual Top Evo 6 and is the answer not in the manual?
Questions and answers