Table of Contents
Advertisement
VW Passat
1
a
1
3
2
1
3
2
2
b
X
Fig. 23
Fig. 24
2
Fig. 25
1
2
5
4
3
Fig. 26
Exhaust Installation
Cut supplied exhaust tubing as shown in figure 23.
– (1) Exhaust tube - a=165 mm (6.5 in.)
– (2) Exhaust endpiece - b=240 mm (9.4 in.)
– (X) Scrap
Install EJOT stud, spacer nut, and muffler on heater as
shown in Figure 24.
– (1) Spacer nut
– (2) Nut and washer
– (3) Muffler
CAUTION
Ensure there is sufficient room between vehicle
components and the heater exhaust tube. Secure
vehicle wiring harnesses with nylon cable ties.
ATTENTION
Assemble exhaust tubing using supplied exhaust wrap
as shown in Figure 25.
Install exhaust tube between heater and muffler with
clamps provided.
– (1) Exhaust wrap
– (2) Exhaust clamp
– (3) Exhaust tube
Install exhaust end piece on heater with clamp.
CAUTION
Ensure the rubber exhaust insulator is positioned inside
the hole in the vehicle splashshield before attempting
to start the heater.
Using the rubber exhaust insulator as a template, mark
and cut a hole through the vehicle splashshield where
shown in Figure 26.
– (1) Muffler
– (2) Exhaust clamp
– (3) Exhaust tube
– (4) Rubber exhaust insulator
– (5) Vehicle splash shield
15
Advertisement
Table of Contents
