Table of Contents
Advertisement
Wireless NVR System User Manual
4.5 PTZ Control (xmartO WOS series do not support PTZ now)
4.5.1 PTZ Parameter Setting
Prerequisites:
Before trying to control the speed dome or PTZ, you need to make sure that the decoder of this PTZ
has already connected to NVR, and also you need to set the parameters for the PTZ in NVR.
Operation Steps:
1. Right click mouse in your system, enter "System setup" – "Channel Setup" – "PTZ", you'll then
see below interface, as shown in Figure 28.
Operation Guide as below:
Operation Target
Channel
Protocol
Device Address
Baud Rate
Copy to
4.5.2 PTZ Control Operations
Operation Steps:
1. Double click the channel you want to set in main preview screen.
2. Right click mouse in that channel's preview interface and choose the PTZ control, you'll then see
below image, as shown in Figure 29.
Function Description
Choose the channel you want to set PTZ
Choose the correct protocol of this PTZ
Enter the specified decoder address
Choose the right baud rate to match with this PTZ's baud rate
Choose the channel you want to copy the settings and click "Copy to" to apply
current channel's settings to other channels
Image 28
26
Advertisement
Table of Contents
