Procedure For Tilting Up - SELVA MARINE MARLIN 100 EFI Owner's Manual

ECM00241
CAUTION:
Before tilting the outboard motor, stop
G
the engine by following the procedure
on page 24. Never tilt the outboard mo-
tor while the engine is running. Severe
damage from overheating can result.
Do not tilt up the engine by pushing the
G
tiller handle (if equipped) because this
could break the handle.
EMU28005

Procedure for tilting up

Power trim and tilt models / power tilt models
1. Place the remote control lever / the gear
shift lever in neutral.
N
2. Disconnect the fuel line from the out-
board motor or close the fuel cock.
3. Press the power trim and tilt switch / pow-
er tilt switch "
motor has tilted up completely.
ZMU03196
" (up) until the outboard
UP
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever toward
you to support the engine.
EWM00260
WARNING
After tilting the outboard motor, be sure to
support it with the tilt support knob or tilt
support lever. Otherwise the outboard mo-
tor could fall back down suddenly if oil in
the power trim and tilt unit loses pressure.
5. Models equipped with trim rods: Once the
outboard motor is supported with the tilt
support lever, press the power trim and
tilt switch " " (down) to retract the trim
rods.
Operation
ZMU04232
28