Remote Menu - Sony TRIMASTER PVM-X2400 Operating Instructions Manual

Time Code
Press the button to display the time code. You
can set the time code under "Time Code"
(page 33).
Quad View
Press the button to display four inputs on the
screen.
WFM
Press the button to display WFM (Wave Form
Monitor).
Vector
Press the button to display Vector (vector scope).
ALM
Press the button to display the audio level meter.
Pixel Zoom
Press the button to use the pixel zoom.
Black Detail High
Press the button to accurately display dark
scenes. Use this when setting a higher range for
the brightness of the display.
Black Detail Mid.
Press the button to accurately display dark
scenes.
Black Detail Low
Press the button to accurately display dark
scenes. Use this when setting a lower range for
the brightness of the display.
Dynamic Cont. Dr.
Press the button to check the balance between
bright and dark scenes.
Under Scan
Press the button to display an image 3% smaller
than the image displayed with scaling (Native
Scan Off).
Notes
The "Black Detail High" to "Black Detail Low"

functions and "Dynamic Cont. Dr." cannot be
used simultaneously.
When "Under Scan" is set to "On," "Native

Scan" is set to "Off."
Some functions are not available in Quad View.

For details, refer to "Quad View Functions and
Adjustable/Setting Items" (page 12).

Remote menu

You can configure the settings for connecting to
an external device that controls the monitor
remotely.
Monitor Network
Submenu
Connection
Network Setting
Monitor ID
Group ID
IP Address
Subnet Mask
Default Gateway
Cancel
Confirm
Controller Network
35
Setting
Set the connection to an external
device.
 Off: Set to Off when this unit is not
controlled remotely.
Peer to Peer: for one to one

connection
LAN: for connection via a network

Sets the ID of this unit.
Sets the group ID of this unit.
Sets the IP address.
Sets the subnet mask.
Sets the default gateway On or Off.
 Address: Sets the default gateway.
Selects to cancel the setting.
Selects to save the setting.