Kyocera FS-2020D Service Manual page 83

1-5-8 PWBs
(1) Detaching and refitting the engine PWB
Procedure
1. Remove the developing unit (See page 1-5-
11).
2. Remove the drum unit (See page 1-5-12).
3. Remove the top cover (See page 1-5-3).
4. Remove the left cover (See page 1-5-4).
5. Remove the PSU fan motor (See page 1-5-
32).
6. Stand the printer front side up.
7. Remove five screws and then remove the
bottom plate1.
8. Remove two screws and then remove the
bottom plate 2.
9. Remove two wires from the hooks and
notches.
10. Open the DU guide (duplex cover).
Downloaded from www.Manualslib.com manuals search engine
Screw
Screw
Screw
(M3)
Figure 1-5-33
DU guide (duplex cover)
Notch
Hook
Wire
Figure 1-5-34
2J0/2J1/2J2
Screw
Screw
Bottom plate 1
Screw
Bottom plate 2
Screw
1-5-25