Kyocera FS-2020D Service Manual page 73

6. Release four latches and then remove the
separation charger brush unit.
7. Check or replace the transfer roller and sep-
aration charger brush unit and refit all the
removed parts.
CAUTION: Note the following, when refitting
the separation charger brush unit.
A. The separation charger brush unit is
inserted into the two projections of the frame
and does not run on to the projections.
B. The separation charger brush unit is
firmly in contact with the separation charger
plate of the frame.
Downloaded from www.Manualslib.com manuals search engine
Latch
Projection
Separation
charger plate
A
Separation charger
brush unit
Viewpoint
B
Separation
charger plate
Viewpoint
Figure 1-5-19
2J0/2J1/2J2
Separation charger
brush unit
Viewpoint
Projection
Frame
Projection
Separation
charger brush
Separation
charger brush unit
1-5-15