Yamaha WR250R Service Manual page 59

1. Clamp
2. Throttle position sensor lead
3. Fan motor lead
A. Fasten the breather hose using a clamp.
B. Fasten the throttle position sensor connector
cover and the rear brake switch lead using a
cable tie.
C. Insert the fan motor lead into the concave sec-
tion of guide air, and pass them backward
through the hole.
D. After connecting the main switch lead, front
brake switch lead, and handlebar right lead,
and place their connectors in the cover.
E. Fasten the main switch lead, front brake switch
lead, and handlebar switch right lead using a
clamp. They must be placed between the front
edge of the cable guide and below the "H",
within the range of the handlebar turns from
straight ahead to the fully left.
F. Slightly pull out the end of rear brake switch
lead backward.
G. Fasten the rear brake switch lead to the frame
with a clamp. The clamp must be securely
inserted into the frame hole. Any locking posi-
tion can be used.
H. The position is a between the halfway from the
cable guide and the upperend of the frame
number.
I. Front edge of the cable guide
2-34
CABLE ROUTING