Yamaha WR250R Service Manual page 14

NOTE:
Indicator " " comes on when tripmeter A is se-
lected, and indicator " " comes on when
tripmeter B is selected.
If the fuel level warning light comes on, the dis-
play will automatically change to the fuel reserve
tripmeter mode "F" and start counting the dis-
tance traveled from that point. In this case, push
the "SELECT 2" button to switch the display be-
tween the various tripmeter and odometer
modes in the following order:
fuel reserve tripmeter "F" → odometer →
tripmeter A → tripmeter B → fuel reserve
tripmeter "F"
NOTE:
The fuel level warning light may not function ac-
curately while riding off road as the fuel level
reading changes due to the movement and incli-
nation of the vehicle.
If the fuel level warning light comes on while
riding in the measurement mode, change to the
basic mode and push the "SELECT 2" button to
display the fuel reserve tripmeter.
NOTE:
To change from the measurement mode to the
basic mode, the stopwatch and the dis-
tance-compensation tripmeter must be stopped.
1
1. Fuel reserve tripmeter "F"
To reset a tripmeter, select it by pushing the
"SELECT 2" button, and then push the "RESET"
button for at least one second. If you do not reset
the fuel reserve tripmeter manually, it will reset
itself automatically and the display will return to
the prior mode after refueling and traveling 5 km
(3 mi).
Clock
Turn the key to "ON".
NOTE:
When setting the clock, push the "SELECT 1"
button to increase the digits or "SELECT 2" but-
ton to decrease the digits. Pushing and holding
either button will increase or decrease the digits
continuously until the button is released.
To set the clock
1. Push the "SELECT 1" button for at least two
seconds.
2. When the hour digits start flashing, push ei-
ther select button to set the hours.
3. Push the "RESET" button, and the minute
digits will start flashing.
4. Push either select button to set the minutes.
5. Push the "RESET" button, and the second
digits will start flashing.
6. Push either select button to set the second
digits to zero.
7. Push the "RESET" button for at least two sec-
onds, and then release it to start the clock.
NOTE:
If the "RESET" button is not pushed within 30
seconds, the clock will not be set and will return
to the prior time.
Changing from the basic mode to the mea-
surement mode
With the odometer selected, push the "SELECT
1" button and "SELECT 2" button together for at
least two seconds to change to the measure-
ment mode.
Changing from the measurement mode to
the basic mode
NOTE:
The stopwatch must be stopped before chang-
ing to the basic mode.
1. Check that the stopwatch is not in operation.
If the stopwatch is in operation, stop it by
pushing the "SELECT 1" button and "SE-
LECT 2" button together.
2. Push the "SELECT 1" button and "SELECT
2" button together for at least two seconds to
change to the basic mode.
Measurement mode (for the stopwatch)
When the measurement mode is selected, the
stopwatch is displayed and it can be started
manually or automatically.
Manual start
The manual start is the default setting for the
stopwatch. The stopwatch indicator " " and the
distance-compensation tripmeter indicator " "
will start flashing.
1-5
FEATURES