Yamaha WR250R Service Manual page 15

1. Push the "RESET" button to start the stop-
watch.
2. Push the "SELECT 1" button and "SELECT
2" button together to stop the stopwatch.
3. To resume stopwatch counting, push the
"SELECT 1" button and "SELECT 2" button
together.
To reset the stopwatch to zero, see "Reset-
ting the distance-compensation tripmeter or
the distance-compensation tripmeter in com-
bination with the stopwatch".
NOTE:
The stopwatch will continue counting when the
vehicle is stopped. To stop and/or resume
counting, repeat steps 2 and 3.
Auto start
1. Push the "SELECT 1" button for at least two
seconds to set the auto start.
NOTE:
When the stopwatch is set to auto start, the stop-
watch indicator " " and the distance-compen-
sation tripmeter indicator " " will start flashing,
and the digits in the display will start scrolling
from left to right.
2. When the vehicle starts moving, the stop-
watch will start counting.
3. Push the "SELECT 1" button and "SELECT
2" button together to stop the stopwatch.
4. To resume counting, push the "SELECT 1"
button and "SELECT 2" button together
again.
NOTE:
The stopwatch will continue counting when the
vehicle is stopped. To stop and/or resume
counting, repeat steps 3 and 4.
Measurement mode (for calibrating the dis-
tance-compensation tripmeter's reading)
The distance-compensation tripmeter is a fea-
ture intended to provide a more accurate
tripmeter reading for enduro riding. Calibrating
this meter in accordance with the distances
specified on the enduro course map will help fa-
miliarize the rider with the course. In addition,
calibrating the meter may also be necessary
when using tire, wheel, chain sprocket sizes,
etc. other than specified.
Calibrate the distance-compensation tripmeter
as follows.
To increase the reading, push the "SELECT 1"
button. To decrease the reading, push the "SE-
LECT 2" button. Pushing and holding either but-
ton will increase or decrease the reading
continuously until the button is released.
NOTE:
Calibrating the reading of the distance-compen-
sation tripmeter is possible regardless of the
stopwatch operation.
Resetting the
tripmeter or the distance-compensation
tripmeter in combination with the stop-
watch
NOTE:
Resetting can be made only to the dis-
tance-compensation tripmeter or to the dis-
tance-compensation tripmeter in combination
with the stopwatch.
Resetting the distance-compensation tripmeter
1. Check that the stopwatch measurement is in
operation.
2. Reset the distance-compensation tripmeter
to zero by pushing the "RESET" button for at
least two seconds.
Resetting the distance-compensation tripmeter
in combination with the stopwatch
1. Stop the stopwatch.
2. Reset the distance-compensation tripmeter
and the stopwatch to zero by pushing the
"RESET" button for at least two seconds.
Self-diagnosis device
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If any of those circuits are defective, the engine
trouble warning light will come on, and then the
display will indicate a two-digit error code.
If the display indicates any error codes, note the
code number, and then check the fuel injection
1-6
FEATURES
distance-compensation