Vermeiren eclips X4 Instruction Manual page 20

* Rear wheel:
1.
Remove the rear wheels (see § 2.13).
2. Loosen the fixing screws Ⓐ from the rear axle block Ⓑ.
3. Push the axle block Ⓑ upwards or downwards to the desired height.
4. Tighten the screws Ⓐ properly.
5. Mount the rear wheels.
6.
Adjust the brakes according § 3.7.
Position 1
Adjustment of the slope nuts Ⓒ from the steering wheels.
L L L L
WARNING:
Risk of injury - Make sure that the eccentric screw settings are
identical on both front-wheel adapters and, before using the wheelchair.
This figure illustrates the principle. The position of the screw thread is indicated by a number.
Position 2
Position 3
A
Shows the frame when the seat is horizontal and the
adapter is perpendicular to the ground.
B Shows the frame when the seat is tilted slightly and the
adapter is not perpendicular.
Page 18
Eclips X4, Eclips X4 30°
2012-01
Position 4