Adding Fuel; Start The Engine - Briggs & Stratton 1695906 Operator's Manual

ADDING FUEL

WARNING:
Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or death.
When Adding Fuel
• Turn engine off and let engine cool at least 3 minutes before
removing the fuel cap.
• Fill fuel tank outdoors or in well-ventilated area.
• Do not overfill fuel tank. To allow for expansion of the fuel, do not
fill above the bottom of the fuel tank neck.
• Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
• Check fuel lines, tank, cap, and fittings frequently for cracks or
leaks. Replace if necessary.
• If fuel spills, wait until it evaporates before starting engine.

START THE ENGINE

Be sure that engine oil is at FULL mark on the oil fill cap/dipstick.
The snowthrower engine is equipped with an A.C. electric starter
and recoil starter. Before starting the engine, be certain that you
have read the following information.
If engine floods, set the choke to the OPEN/RUN position and
crank until the engine starts.
WARNING: The electric starter is equipped with a three-
wire power cord and plug designed to operate on AC
house hold current. The power cord must be properly
grounded at all times to avoid the possibility of electric
shock which can cause injury to the operator. Follow all
instructions carefully as set forth:
Make sure your house has a three-wire grounded system.
If you are not sure, ask a licensed electrician. If your house
does not have a three-wire grounded system, do not use this
electric starter under any condition.
If your house has a three-wire grounded system but a three-
hole receptacle is not available to connect the electric
starter, have a three-hole receptacle installed by a licensed
electrician.
WARNING: To connect power cord, always connect the
power cord first to the switch box located on the
engine and then plug the other end into a three-hole
grounded receptacle.
WARNING: To disconnect the power cord, always
unplug the end connected to the three-hole grounded
receptacle first.
en
1. Clean the fuel cap area of dirt and debris. Remove the fuel
cap (H, Figure 3).
2. Fill the fuel tank with fuel. To allow for expansion of the fuel,
do not fill above the bottom of the fuel tank neck.
3. Reinstall the fuel cap.
Start the engine as follows:
1. Check the oil level.
2. Make sure equipment drive controls are disengaged.
3. Move the throttle control lever (A, Figure 10) to the FAST
position. Operate the engine with the throttle control in the fast
position.
4. Turn the fuel shut-off valve (B) to the ON position.
5. Insert the ON/OFF key (C) and turn to the ON/START position
6. Turn the choke control knob (D) to the CHOKE position.
NOTE: Choke is usually unnecessary when restarting a
warm engine.
7. Push the primer (E) two times.
NOTE: Priming is usually unnecessary when restarting a
warm engine.
D
E
C
B
A
Starting the Engine
OPERATION
Figure 10
17